For the plasma cutting we have 6 systems managed by the computer.
The versatility of the cutting systems that we use allows us to reach the thickness range from 3 to 150 mm, circular cuts from 50 to 3000 mm (depending on the used thickness) - Rectilinear cuts up to 13000 mm with tolerances that can vary depending on the thickness from -0/+3 to -0/+15 mm.

Our machineries allow to make cuts up to 300 mm without any structural alterations of the cut area. The systems that are equipped with belt saw allow us to deliver stainless steel plates coming from plates with thickness varying from 12 to 300 mm.

- Maximum length up to 6000 mm

- Maximum width up to 2400 mm

With tolerances of about -0/+2mm, parallelism +/-0.5 mm, without any alteration and with a perfectly vertical cut edge.

Machineries with a precision level up to 15 mm.

For who needs a high level of cut precision, the laser cut allows the work of details in the following sizes:

- Thickness from 0.5
    to 15 mm

- Max. length 6000 mm

- Max width 3000 mm

Dimensional tolerances
of -0/+02 mm with light deviations as regards the thickness.

Very regular cut edges with an almost imperceptible material alteration.

 

At this purpose our Technical Department is always available at the following address: drawing@csai.net

home - company - elaboration - stock - contact us